Monitoring Mode - Innomed Medical HS112 C-1 User Manual

8. Monitoring mode

After switching the device on by pushing the on/off power button, the device will perform a
self-test.
If there is an error during the test, the device will display the error, otherwise it will enter into
monitoring mode. During the test, the device will also perform a memory check, and while
"Memory x% OK" is displayed, the touch buttons cannot be used.
Monitoring mode is the default state of the device: the chosen number of ECG channels is
displayed, as well as the patient's name, their heart rate, curve sweep speed and sensitivity,
filter settings, and other status notifications (battery, wireless connection status, pacemaker
pulse presence, etc.).
After turning the device on, monitoring will always start with the latest settings (retained after
shutdown), with the exception of the baseline filter which is turned on for the printer and
turned off for the display at each start-up.
The following figure shows the information displayed during monitoring.
 If a wireless connection is available, an indicator icon appears on the right side of the
display. Wireless communication can be disabled by touching the icon, which then
becomes crossed out. If the connection is turned on again (by touching the icon), the
icon is no longer crossed out. If the icon is in inverse colour, the connection is active,
and if it is not in inverse colour, there is no connection (the receiver is turned off or
there is no network available).
 The pacemaker symbol "Pace" appears when the patient examined has an active
pacemaker and the device detects it. In these cases, a marker line coloured differently
from the ECG curve indicates the pacemaker spikes.
20/73
HS112 C-1 User Manual
R-6730-EN02-E