JUMO IPC 300 Operating Manual page 82

8 Error messages and alarms
Error message
[xxx] Invalid
configuration
Wire break ext.
current sensor 2, 3
82
Cause
Ext. current sensor 3:
043 Measurand
044 Sensor outp. signal
045 Outp. meas. range start
046 Outp. meas. range end
047 Sensor input measuring range
048 Input meas. range start
049 Input meas. range end
050 Limit value error current
051 Limit value load current
052 Power reduction
054 Limit value monitoring function
055 Limit value min. alarm
056 Limit value max. alarm
057 Limit value hysteresis
058 Load monitoring
059 Limit value load mon.
060 Teach-In type load mon.
061 Load mon. Teach-In
062 SiC monitoring
064 Changeover setpt. spec.
065 Setpoint specification for
changeover
066 Setpoint value for changeover
067 Keyboard lock
068 Ext. switch-off display lighting
069 Ext. Teach-In load mon.
070 Control direction inhibit inpt.
071 Control direction dig. inpt. 1
072 Control direction dig. inpt. 2
074 Output mode digital outp.
075 Control direction dig. outp.
080 Signal type analog outp.
081 Value to be output
082 Signal range start value
083 Signal range end value
085 Baud rate
086 Data format
087 Device address
088 Min. response time
090 Code, manual mode
091 Code, operating lev.
092 Code, config. level
094 Undocument. int. param. 1
...
143 Undocument. int. param. 50
145 Undocument. float param. 1
...
169 Undocument. float param. 50
Input current/voltage at external current
sensor 2/3 too small for the set measuring
range.
Remedy
Check wiring of the external current
sensor for wire breaks and reverse
polarity
V1.00/EN/00741192/2021-03-30 [IPC 300]