Table of Contents
Advertisement
6.3 Manual mode
6.3.1 Setpoint specification in manual mode
Starting
The setpoint value for manual mode is not saved in the event of a power failure!
6.3.2 Configuring Teach-In (prerequisite for Teach-In in manual mode)
Configuring
"manual"
Teach-In
V1.00/EN/00741192/2021-03-30 [IPC 300]
with time due to aging.
When the power controller is disconnected from the mains voltage, the Teach-
In values detected last are deleted and recalculated once the mains voltage
supply has returned.
In this case, the setpoint value can be manually preset from 0 to 100 % with-
out the need for external wiring via the analog input.
Manual mode, as set per default, can be accessed without entering a code.
h Press the
key once (selection menu)
h Press the
key again (manual mode)
h Use the
or
The changes become effective immediately at the load output and are indicat-
ed on the display.
Setpoint value
Load voltage
The Teach-In function records the current/voltage ratio of a load in the OK
state.
The power controller is in the "Measured value overview" level.
h Press the
key
r
Config. level
Monitoring
r
Teach-in type load monit.
h Press the
key
II
h Press the
key twice
If Teach-In is being performed for the first time, the message "Teach-In miss-
ing" appears in the bottom line of the display.
6 Special device functions
key to increase or decrease the setpoint value
r
Load monitoring
r
Set to "manual"
Load current
r
Undercurrent or overcurrent
67
Advertisement
Table of Contents
