Table of Contents
Advertisement
5 Configuration
Control direction,
digital input2
5.1.8
Binary output
Output mode
58
Value / settings
high inactive
high active
k
/ bold = default setting
The digital output consists of a relay or an optocoupler, depending on the or-
der code.
With the digital output, it is possible to choose between the output mode "col-
lective fault transmitter", or "Interf. signal".
v Chapter 8.1 "Binary signal for collective fault"
The control direction is used to select the switching behavior of the relay and
determine whether, in the event of an error message, if it should switch on (er-
ror message via N/O contact) or drop out (error message via N/C contact). In
the optocoupler, the control direction determines whether the collector-emitter
loop should be conductive or high-impedance in the event of an error mes-
sage.
h
key
Use the
to switch to the configuration level
Value /
Description
settings
Collective
The digital output switches if a collective fault occurs on the device. This
fault trans-
can be configured as an "N/C contact" or as an "N/O contact" (see be-
mitter
low).
The K1 LEDs also light up in the event of a fault.
Interf. sig-
The digital output is controlled via an interface
nal
k
/ bold = default setting
Description
The function for digital input 2 can be triggered for "high or low
switching level".
V1.00/EN/00741192/2021-03-30 [IPC 300]
r
Digital output
Advertisement
Table of Contents
