Voltage Measuring Range, Start; Voltage Measuring Range, End; Setpoint Configuration; Setpoint Specification - JUMO IPC 300 Operating Manual

Voltage measuring
range, start
Voltage measuring
range, end
5.1.4

Setpoint configuration

Value / settings
Setpoint specifica- Current input
tion
Voltage input
Via interface
Input in the event
of an error
Last value
Voltage input
Current input
Value, adjustable
Value in the event 000.0
of an error
V1.00/EN/00741192/2021-03-30 [IPC 300]
Value / settings
0 to 10 V
0 to 10 V
k
/ bold = default setting
1.
Inverting analog inputs:
If, for example, the current measuring range start is set to 20 mA and the current measuring range end
is set to 0 mA, the power controller is switched off at 20 mA and switched on at 0 mA.
This setting determines which input specifies the setpoint value, how high the base
load is, and which replacement value should be applied in the event of malfunction.
Description
This setting specifies where the setpoint value for the power
output comes from.
Current, voltage, and interface input are monitored for errors
(wire breaks or bus errors). This setting specifies which replace-
ment value the power controller should use if the setpoint spec-
ification is incorrect.
If, for example, an error (e.g. wire break) now occurs at the cur-
rent input that is selected for the default setpoint specification,
the power controller uses the value at the voltage input.
This means that the "Value in the event of an error" is used.
If "Value, adjustable" is configured as the error value, this value
is used in the event of a malfunction.
Description
Note: This parameter only appears if "Customer specific" is
set for the voltage measuring range (see above)!
Note: This parameter only appears if "Customer specific" is
set for the voltage measuring range (see above)!
5 Configuration
53