Table of Contents
Advertisement
Current deviation from
Teach-In.
I.e. at > 0 %
the load has become
more high-resistance; at
< 0 % the load is more
low-resistance
4.2.5 Binary inputs
Value range Description
0 to 9999.9
k
V1.00/EN/00741192/2021-03-30 [IPC 300]
0 to 1 to
The switching differential at the minimum or maximum limit value
9999.9
0 to 10 to
Partial load failure or partial load short circuit:
100%
The monitoring value for the percentage change to the load is set
(undercurrent or overcurrent).
By displaying the current deviation from the Teach-In value, it is
possible to check whether, for example, an output-level-depen-
dent resistance change is present.
By pressing the
the OK state for load monitoring.
A change in the load (load fault) will be evaluated by the de-
vice on the basis of this state.
k
/ bold = default setting
First of all, a setpoint changeover via digital inputs must be configured.
v Chapter 5.1.7 "Binary inputs"
A setpoint value specified via the analog input, as set in Chapter 5.1.3, is
changed over to the value entered here (50 V), for example via Digital input 1.
Here the setpoint value is entered which is to become effective for the
changeover via a digital input.
/ bold = default setting
4 Operation
key, the current load state is applied as
47
Advertisement
Table of Contents
