Compatibility Command Summary - Agilent Technologies N6751A User Manual

Compatibility Command Summary

Agilent 662xA Command
ASTS? <ch>
CLR
CMODE <on/off>
CMODE?
DC <ch>, < on/off >
DC? <ch>
DCPON < on/off >
DCPON?
DLY <ch>, <delay>
DLY? <ch>
DSP <on/off>
DSP?
DSP " xxxxxxxxxxxx"
ERR?
FAULT? <ch>
ID?
IDATA <ch>, <Ilo>, <Ihi>
Series N6700 User's Guide
The following table documents the compatibility commands that the
Agilent N6700 MPS supports. All compatibility commands are
accepted; however, some commands will generate an error.
Description
Queries the accumulated status (ASTS) of the specified output channel.
The response represents the sum of the binary weights of the ASTS
register bits. The ASTS register is automatically set to the present status
after being queried.
Returns the entire power system (all outputs) to the power-on state, except
the unit is not unaddressed and its store/recall registers are not changed.
Generates error −113. The unit must be calibrated using SCPI commands.
Generates error −113. The unit must be calibrated using SCPI commands.
Turns the specified output channel on or off. On/off = 0 turns the channel
off; on/off = 1 turns the channel on.
Queries whether the specified output channel is on or off. Response is
either 1 (on) or 0 (off).
Sets the power-on state of the output channels. For on/off = 0, all outputs
will be off state when the unit is turned on. For on/off = 1 all outputs will
be in the on state when the power system is turned on. This command
requires the output power-on state to be set to RCL0.
Returns a 1 if any channels are set to turn on their output at power on.
Sets the reprogramming delay for the specified output channel. This delay
is used to mask the CV, CC, CP-, UNR, and other status bits from the fault
register and the OCP function for the specified delay period.
Queries the present reprogramming delay of the specified output channel.
Does nothing.
Always returns a 1.
Does nothing.
Queries the present programming or hardware error. An error code number
is returned over the GPIB to identify the error.
Queries the fault register of the specified output channel. A bit is set in the
fault register when the corresponding bit in both the status and the mask
registers. The response is an integer 0 to 255. The fault register is cleared
after being read.
Queries the model number of the power system.
Generates error −113. Unit must be calibrated using SCPI commands.
Compatibility Appendix E
Similar SCPI
Command
STAT:OPER:EVEN?
STAT:QUES:EVEN?
*ESE?
*RST
see Appendix B
see Appendix B
OUTP:STAT
OUTP:STAT?
OUTP:PON:STAT
RCL0
OUTP:PON:STAT?
OUTP:PROT:DEL
OUTP:PROT:DEL?
None
None
None
SYST:ERR?
STAT:OPER?
STAT:QUES?
*ESE?
*IDN?
see Appendix B
193