Agilent Technologies N6751A User Manual page 92

6 Language Dictionary
[SOURce:]LIST:COUNt <count>|MIN|MAX|INF, (@<chanlist>)
[SOURce:]LIST:COUNt? [MIN|MAX,] (@<chanlist>)
[SOURce:]LIST:CURRent[:LEVel] <curr> {,<curr>}, (@<chanlist>)
[SOURce:]LIST:CURRent[:LEVel]? (@<chanlist>)
[SOURce:]LIST:CURRent:POINts? (@<chanlist>)
[SOURce:]LIST:DWELl <time> {,<time>}, (@<chanlist>)
[SOURce:]LIST:DWELl? (@<chanlist>)
[SOURce:]LIST:DWELl:POINts? (@<chanlist>)
92
This command sets the number of times that the list is executed
before it is completed. Applies only to models with list capability.
The range is 1 through 256. Use INFinity to execute a list indefinitely.
In this case, use ABORt:TRANsient to stop the list.
The *RST value = 1.
This command specifies the current setting for each list step in
amperes. Applies only to models with list capability. A comma-
delimited list of up to 512 steps may be programmed.
The *RST value = 1 step with a value of MIN.
This query returns the number of points (steps) programmed in the
current list. Applies only to models with list capability.
This command specifies the dwell time for each list step. Applies only
to models with list capability. A comma-delimited list of up to 512
steps may be programmed. Dwell time is the time that the output will
remain at a specific step. Dwell times can be programmed from 0 to
262.143 seconds with the following resolution:
Range in seconds Resolution
0 to 0.262143 1 microsecond
0 to 2.62143 10 microseconds
0 to 26.2143 100 microseconds
0 to 262.143 1 millisecond
At the end of the dwell time, the output state of the unit depends
upon the LIST:STEP program settings. See LIST:STEP
The order in which the values are entered determines the sequence
when the list executes.
The *RST value = 1 step with a value of 0.001.
This query returns the number of points (steps) in the dwell list.
Applies only to models with list capability.
Series N6700 User's Guide