Table of Contents
Advertisement
Chapter 3 BIOS Configuration
Boot Sequence
This field determines the drive that the system searches first for an
operating system. The options are :
A, C, SCSI
C, A, SCSI
C, CDROM, A
CDROM, C, A
The default value is A, C, SCSI.
Swap Floppy Drive
This item allows you to determine whether to enable the swap Floppy
Drive or not. When enabled, the BIOS swaps floppy drive assignments so
that Drive A becomes Drive B, and Drive B becomes Drive A. By
default, this field is set to Disabled.
Boot Up Floppy Seek
When enabled, the BIOS will seek whether or not the floppy drive
installed has 40 or 80 tracks. 360K type has 40 tracks while 760K, 1.2M
and 1.44M all have 80 tracks. By default, this field is set to Enabled.
Boot Up NumLock Status
This allows you to activate the NumLock function after you power up the
system. By default, the system boots up with NumLock On.
Boot Up System Speed
This has no function and selects the default system speed (High).
Gate A20 Option
This field allows you to select how Gate A20 is worked. The Gate A20 is
a device used to address memory above 1 MB. By default, this field is set
to Fast.
Security Option
This field allows you to limit access to the System and Setup. The default
value is Setup. When you select System, the system prompts for the User
Password every time you boot up. When you select Setup, the system
always boots up and prompts for the Supervisor Password only when the
Setup utility is called up.
42
D, A, SCSI
SCSI, C, A
E, A, SCSI
C only
F, A, SCSI
LS120, C
SCSI, A, C
CI5TTV User's Manual
Advertisement
Table of Contents
