Furuno DSC-60 Operator's Manual page 122

Auto ack setup
**
COMPLY TYPE
UNABLE REASON :
NO REASON GIVEN
POSITION CALL
POLLING CALL
7-4
[ENT] key
**
[ENT] key
: ABLE
: OFF
: ON
[ENT] key
[ENT] key
Default: ABLE
or
ABLE
to set.
UNABLE
Choose ABLE or UNABLE as automatic
acknowledgement reply to Individual, Position
and Polling messages.
Note: Automatic acknowledge is automatically
disabled when Rx message contains error,
as required by law. Further, automatic
acknowledge is disabled in case of OFF
HOOK.
Automatic acknowledge of Position or
Polling request is not available when
UNABLE is selected.
Default: NO REASON
NO REASON
BUSY
EQUIP DISABLED
MODE NOT USABLE
CH NOT USABLE
Sets reason for UNABLE.
Note: This menu is the same as manual
acknowledgement. EQUIPMENT
DISABLED is shown in messages when
EQUIP DISABLED is selected.
Default: ON
Overrides/follows AUTO ACK setting
ON
in case of position.
OFF
OFF: Disables automatic
or acknowledgement of position
to set. request.
ON: Enables automatic
acknowledgement of position
request.
Default: ON
Overrides/follows AUTO ACK setting
ON
in case of polling.
OFF
OFF: Disables automatic
acknowledgement of polling
or
request.
to set.
ON: Enables automatic
acknowledgement of polling
request.
or
to set.