Connecting The Ie850A And Target System; Emulator Connector For External Tracing - Renesas IE850A User Manual

IE850A

Connecting the IE850A and Target System

4. Connecting the IE850A and Target System
To connect the IE850A to the target system, a connector for the emulator must be mounted on the
target system. When designing the target system, read this chapter and the hardware manual for the
MCUs to be used.
4.1

Emulator Connector for External Tracing

Table 4-1 shows the recommended connectors for connection of the IE850A. When other components
are mounted around the connector, do not mount components with heights exceeding 6 mm on the user
system as shown in Figure 4-1.
Table 4-1 Recommended Connector
Product Manufacturer Type Number
34-pin connector SAMTEC ASP-137973-01
5 mm
5 mm
5 mm
5 mm
Figure 4-1 Area where Restriction Applies to Mounted Components
R20UT4461EJ0110 Rev. 1.10 Page 25 of 40
Apr.22.19