Table of Contents
Advertisement
LDAP Settings
To allow authentication and authorization via LDAP or LDAPS, the Active
Directory's LDAP Schema must be extended so that an extended attribute
name for the RCMDVI101 or RCMVGA101 / RCMDP101U – iKVM50-
userProfile or iKVM57-userProfile – is added as an optional attribute to the
person class.
Users can find the attribute name of the unit by executing a get command on
the Terminal page, see page 44.
In order to configure the LDAP server, you will have to complete the following
procedures: 1) Install the Windows Server Support Tools, 2) install the Active
Directory Schema Snap-in, and 3) extend and update the Active Directory
Schema.
To allow authentication and authorization for the RCM KVM over IP Switch
via LDAP / LDAPS, refer to the information in the following table.
Item
Enable
Preferred / Alternate
LDAP
Server IP
Port
Timeout (seconds)
Admin DN
Check Enable to allow LDAP / LDAPS authentication and
authorization.
Click for a drop-down menu to select Preferred LDAP or
Alternate LDAP.
Fill in the IP address and port number for the server. The
default port numbers for LDAP and LDAPS are 389 and 636
respectively.
Set the time in seconds that the RCM KVM over IP Switch
waits for an LDAP or LDAPS server reply before it times out.
Consult the LDAP / LDAPS administrator to ascertain the
appropriate entry for this field. For example, the entry might
look like this:
cn=LDAPAdmin,ou=cn9600,dc=aten,dc=com
Chapter 5. Configuration
Action
55
Advertisement
Table of Contents
