Footrest Folding Up To One Side - Proactive TRAVELER Service Booklet

TRAVELER usage instructions
Bottom M6 fixing screw
with washer (positioning
in the slot)
Figure 103: Bottom M6 fixing screw can be posi-
tioned in the slot
To adjust the lower leg length, the respective
M6 fixing screw (AF 4 mm) is now loosened on
both sides. The footrest support tubes are then
moved in the hole grid or along the slots into
the correct position. Observe that the footrest
support tubes are both the same length on
both sides after they have been adjusted.
Once the position has been set, fix the footrest
support tubes by tightening the M6 fixing
screws (AF 4 mm) with washers to 11 Nm on
both sides.
Note:
With a V-shaped product frame or with a larger
lower leg width at the top than the bottom, it is
necessary to relieve the footrest support tube
tension in the footrest support plate resulting
from longitudinal adjustment. In this case, the
M6 fastening clamp screws (AF 5 mm) on the
footrest support plate therefore have to be
opened before starting to adjust the lower leg
length. View the procedure in Chapter 24.1.

24.4 Footrest folding up to one side

Figure 104: Footrest folding up to one side, stand-
ard position
For footrest folding up to one side, lift the
footplate support up in the direction of travel on
the left side.
Footplate support
Figure 105: For folding up to one side, lift the foot-
rest up in the direction of travel on the left side
(product view from the front)
Bracket with
cylinder pin
Figure 106: Footplate support raised from the
bracket (product view from the front)
40