Footrest Continuous - Proactive TRAVELER Service Booklet

To unlock the footrest,
release or position
perpendicular to the
holder
Figure 98: Locking bolt lever in standard position,
footrest locked; to remove the footrest, position the
locking bolt lever perpendicular
Figure 99: Locking bolt lever released or set perpen-
dicular to the holder to remove the footrest
To attach the footrest, release the folding
mechanism from its locking position (Chapter
17.1), set the locking bolt lever to the standard
position (as long as the footrest holder tubes
are not yet locked in the frame tubes, the lock-
ing bolt lever does not yet lie fully against the
holder) and insert the footrest with the holder
tubes back into the frame tubes until the foot-
rest audibly locks into place.
Insert the
support
tubes into the
frame tubes
Figure 100: Insert the support tubes into the frame
tubes until the footrest locks into place with an audi-
ble sound
39
Locking pin lever
TRAVELER usage instructions
Recommended care:
Greasing the footrest support tubes slightly
with multi-purpose grease at regular intervals
is recommended.

24.3 Footrest continuous

Figure 101: Footrest continuous
To adjust the length of the footrest support
tubes or adapt the lower leg length, there
are two M6 fixing screws on each footrest sup-
port tube. The upper M6 fixing screw (AF
4 mm) can be repositioned via a hole grid
(three positions are generally available). The
bottom M6 fixing screw (AF 4 mm) can be
moved infinitely in a slotted hole. Depending
on the extent of the length adjustment, only
one of the fixing screws or both of them can be
moved in their position.
Top M6 fixing screw
with washer (positioning
in the hole grid)
Figure 102: Top M6 fixing screw can be positioned
in the hole grid
Support tube