Proactive TRAVELER Service Booklet page 58

system must be observed in the following
guidelines and safety instructions.
The wheelchair must only be transported
in the direction of travel in the vehicle, as it was
tested facing forwards in the direction of travel
according to ISO 7176-19.
Figure 163: Incorrect positioning of the wheelchair in
the vehicle
Figure 164: Correct positioning of the wheelchair in
the vehicle
The two rear belts (retractors) must be ar-
ranged symmetrically and anchored at an an-
gle of 30° to max. 45° from the horizontal on
the vehicle floor. The two front belts must also
be arranged symmetrically, and the angle from
the horizontal must lie in the 40° to max. 60°
range. The retractors for the front and rear
must not be swapped.
57
TRAVELER usage instructions
Figure 165: Run of the retractors at the front and
rear with maximum tensioning angle and connecting
points (view from the side)
The two rear belts must each be fastened sym-
metrically at a max. angle of 10° outwards from
the vertical.
Figure 166: Run of the retractors at the rear with
maximum tensioning angle and attaching points
(view from the rear)
The two front belts must also each be fastened
symmetrically at a max. angle of 25° outwards
from the vertical.