Swing Away Footrest - Proactive TRAVELER Service Booklet

TRAVELER usage instructions
support plates can be moved back to the cor-
rect position by opening the M6 fastening
clamp screws (AF 5 mm) on the footrest sup-
port plates. View the procedure in Chapter
24.1.

24.7 Swing away footrest

Figure 118: Swing away footrest,
in standard position
To fold up one of the two footrest parts, grasp
it and fold it up to the side. Moreover, you can
also turn or pivot the footrest outwards.
Figure 119: Both footrest parts folded up and piv-
oted outwards
To remove the footrest parts, place the locking
pin lever vertical to the bracket towards the
front on both sides and then pull both footrest
parts upwards out of the bracket.
Move the locking pin lever
perpendicular to the bracket
Locking pin lever
Figure 120: Moving locking pin lever perpendicular
to remove swing away footrest
Figure 121: Swing away footrest removed
To adjust the length of the footrest support
tubes or adapt the lower leg length, the M6
fixing screws (AF 4 mm) must be released on
both sides. The footrest support tubes are then
pushed along their slots and thus brought into
the correct position. Observe that the footrest
support tubes are both the same length on
both sides after they have been adjusted.
44