Table of Contents
Advertisement
TRAVELER usage instructions
Extreme caution is needed when crossing
main roads, intersections and level crossings.
Rails in the road or level crossings must never
be crossed when travelling parallel to them, as
otherwise the wheels could become caught
which would result in the product being unable
to manoeuvre.
Extreme caution is needed when driving
on ramps and lifting equipment on vehicles.
Ensure in advance that the ramp is wide
enough so that you do not risk the product
wheels slipping off the ramp. When lifting or
lowering a ramp or lifting equipment, the park-
ing brake of the product should be applied. Al-
ways keep the product in the middle of the
ramp.
The grip of the tyres on the ground is re-
duced under wet conditions. There is an in-
creased risk of slipping. Adjust your driving,
braking and steering behaviour accordingly.
16 Safety instructions – after driv-
ing/use
Apply the parking brake before getting out
of the product.
When getting out of the wheelchair, do
not tread on the footrest due to the risk of tip-
ping over.
17 Folding mechanism
17.1 Folding and pack size
To fold the product, remove the seat cushion
and then unlock the folding mechanism by pull-
ing on the cord attached to the middle of the
folding mechanism. Now unlock the back cross
bar by pushing the back cross bar downwards
in the middle.
Cord
Figure 1: Cord for the folding mechanism
Figure 2: Back cross bar unlocked
Note for versions with a back shell: If the
product is equipped with a back shell, the shell
must be removed before unlocking the folding
mechanism (Chapter 19.3). In this version, the
back cross bar unlocks upwards. Otherwise,
the procedure is as described.
Fold the product by pulling out the seat cover
upwards and by pressing the product together
on the sides.
Figure 3: Pack size after folding together and folding
down the backrest
12
Advertisement
Table of Contents
