Safety Push Handles Back-Positioned - Proactive TRAVELER Service Booklet

Figure 148: Put the clamp lever in another angle po-
sition by pulling out
To remove the push handles, turn the clamp
lever out on each side (by turning anti-clock-
wise). Then the push handle can be removed
from the back tube.
To attach the push handles, insert them into
the back tubes. Then insert the clamp lever
into the hole in the back tube and the push
handle thread. Finally, tighten the clamp lever
again (by turning clockwise).
27.5 Safety push handles back-posi-
tioned
Adjusting the height of back-positioned push
handles is possible without tools using the
quick release levers. For adjusting, the quick
release levers are opened and closed again af-
ter adjusting. The height can be infinitely ad-
justed. We recommend adjusting both push
handles to the same height.
Video Height adjustment of safety
push handles offset to the back :
https://www.youtube.com/watch?v=Zg48r
wFHCIE
53
Pull the clamp
lever out vertically
to the rotary axle
TRAVELER usage instructions
Quick release lever
Figure 149: Closed quick release lever
To remove the push handle, the M4 end stop
screw (AF 3 mm) needs to be unscrewed and
the quick release lever needs to be opened.
M4 End stop screw
Figure 150: M4 end stop screw mounted at the bot-
tom of a push handle offset to the back
To attach them, the push handles are inserted
and held at the correct height, and the quick
release levers are closed. Finally, the M4 end
stop screws (AF 3 mm) are screwed in again.
If necessary the tension can be adjusted
by turning the quick release lever clockwise
until it reaches the end stop.
Each time prior to use, the M4 end stop
screws (AF 3 mm) must have been mounted
again.
Open