Adjusting The Clothing Guard Position - Proactive TRAVELER Service Booklet

Cord
Pull from the
middle to the
front
Figure 58: Cord for pulling the locking pin
Observe: In case you are sitting in the
product when removing the clothing guard, you
have to relieve the backrest before pulling the
cord.
Now, first the clothing guard can be removed
from the side panel guide for the mounting bar
(then the cord can be released again) and
pulled from behind the back joint shaft.
Figure 59: Clothing guard pulled from the side panel
guide to the front (shown without drive wheel)
To mount the clothing guard, this is first con-
nected to the rear of the back joint shaft with
the mounting bar, then the mounting bar is in-
serted at the front in the side panel guide and
pressed downwards until the locking pin en-
gages in the mounting bar.
27
TRAVELER usage instructions
Figure 60: Mounting bar pinned on the back jointed
shaft (shown without drive wheel)
21.3 Adjusting the clothing guard posi-
tion
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
After adjusting the drive wheel position or in-
stalling different tyres on the drive wheels, it
may be necessary to adjust the position of the
clothing guard on the wheel arch. The distance
between the tyres and the clothing guard
should be between 5 and 8 mm to avoid pinch-
ing your fingers, scraping the tyres on the
clothing guard, and obstruction when grasping
the handrim.
To adjust the clothing guard position, loosen
the two M5 fixing screws (AF 3 mm) from the
clothing guard mount on each of the clothing
protection guards.
Figure 61: Clothing guard mount
Clothing guard
mount