Safety Instructions; Anti-Tipping Support; Operating And Passive Position - Proactive TRAVELER Service Booklet

M6 fixing screw
with washer
Figure 122: M6 fixing screw with washer to adjust
the lower leg length
Once the position has been set, fix the footrest
support tubes by tightening the M6 fixing
screws (AF 4 mm) with washers to 11 Nm on
both sides.

24.8 Safety instructions

Ensure when setting the lower leg length,
that no strong pressure is produced between
the underneath of the lower leg of the wheel-
chair user and the edge of the seating system.

25 Anti-tipping support

To minimise the risk of tipping backwards unin-
tentionally, anti-tipping supports are available
as accessories. The anti-tipping supports are
adapted to the frame via anti-tipping support
adapters and can be swivelled under the frame
using a spring system.
45
TRAVELER usage instructions
Anti-tipping
support adapter
Anti-tipping
wheel
Anti-tipping bar
Figure 123: Anti-tipping support

25.1 Operating and passive position

To overcome an obstacle, the anti-tipping sup-
port must be swivelled from the operating to
the passive position beforehand so that this
does not knock against the obstacle.
Figure 124: Operating position of anti-tipping sup-
port (view from the rear)