Table of Contents
Advertisement
TRAVELER usage instructions
M6 fixing screw with washer
Figure 96: M6 fixing screw on the frame outer side
4. Using the aid of the angle, move the caster
wheel bearing block in a vertical position to
the level ground.
5. Tighten the M6 fixing screws (AF 5 mm)
again on the frame outer and
inner side to a tightening torque of 10 Nm
and recheck the vertical setting.
6. Screw the M5 stud bolt (AF 2.5 mm) back
in so that it rests on the M6 fixing screw.
After adjusting the caster wheel bearing
block twice, renewing the thread-locking fluid
for the M6 fixing screws (AF 5 mm) on the
outer and inner sides of the frame is recom-
mended.
Note:
To reduce caster wheel flutter, it may be nec-
essary to tilt the caster fork rotary axles from
the vertical (Chapter 23.4).
24 Footrests
Make sure the ground clearance under
the footrest is sufficient. Experience shows that
this should not be less than 4 cm. This must be
observed for the angle adjustment of the foot-
plate support and when setting the lower leg
length.
24.1 Angle adjustment of the footplate
support
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
The angle of the footplate support can be set
by releasing the M6 fastening clamp screws
(AF 5 mm) on the lower side of the footrest
support plate. When the angle adjustment is
completed, tighten the M6 fastening clamp
screws (AF 5 mm) again to maximum 5 Nm.
This tightening torque should not be exceeded
as higher tightening torques can damage the
clamp.
Footrest support plate
M6 fastening clamp screws
Figure 97: Footrest from below
24.2 Removing and attaching the foot-
rest
To remove the footrest, release the folding
mechanism from its locked position (Chapter
17.1) and unlock the footrest by releasing the
locking bolt lever on both sides or by position-
ing it perpendicular to the holder. Then pull the
footrest with the support tubes out of the frame
tubes.
Footplate support
38
Advertisement
Table of Contents
