Table of Contents
Advertisement
Distance
Markings
Figure 73: Distance between the markers on the
tyres (at axle height), back
22.3 Wheel camber
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
The wheel camber increases the lateral stabil-
ity of the product but also increases the overall
width of the product.
The wheel camber will be configured as or-
dered and can be subsequently changed by re-
placing the camber wedges. If you want to
make a change to the wheel camber, please
contact your rehabilitation specialist dealer or
PRO ACTIV.
Figure 74: Various camber wedges
22.4 Tyre pressure
Check the tyre inflation pressure at regular in-
tervals as well as after extreme influence of
temperature (not on solid rubber tyres). The
maximum and if applicable, minimum tyre
pressure is printed on the side of the tyre.
This should be observed.
31
TRAVELER usage instructions
If the tyre pressure is too low, the opti-
mum functional capability of the knee lever
brake is not guaranteed, and an excessively
low tyre pressure negatively influences the
driving behaviour. Apart from that, there is an
increased risk of a flat tyre.
The tyre pressure increases with the tem-
perature. If the pressure is too high, the tyre
may burst. For this reason, product tyres may
not be exposed to unusually high temperatures
such as in a sauna or under glass in the sum-
mer.
When inflating the tyres, make sure that
the prescribed air pressure is not exceeded.
To check or correct the tyre pressure, pro-
ceed as follows:
1. Secure the product to prevent it rolling
away.
2. The drive wheel is normally fitted with a car
tyre valve. Unscrew the valve cap.
Figure 75: Valve with cap
3. Place the valve attachment of the com-
pressed air device or the compressor onto
the valve (if necessary, an adapter must be
placed on the valve attachment) and, if a
clamp lever is fitted, secure the connection
by applying the lever.
4. Now check the tyre pressure. If the tyre
pressure does not match the specifica-
tions, correct it.
Valve with cap
Advertisement
Table of Contents
