Push Handles, Horizontally Screwed In Back Tube; Safety Push Handles With Continuous Height Adjustment - Proactive TRAVELER Service Booklet

TRAVELER usage instructions
To install the push handles, place these in the
back tube and insert the M6 fixing screws (AF
4 mm) (with washers) into the each of the
holes of the back tube and push handle.
Tighten the M6 fixing screws (AF 4 mm) to
11 Nm torque and secure them with thread-
locking fluid.
27.3 Push handles, horizontally
screwed in back tube
Figure 145: Push handles, horizontally screwed in
back tube
It is not possible to adjust these push handles.
To remove the push handles, turn these coun-
ter-clockwise out of the back tube.
Screwing out
Figure 146: Screw the push handle horizontally out
of the back tube
To install the push handle, turn it into the back
tube clockwise and tighten it to a maximum
hand tightness.
27.4 Safety push handles with continu-
ous height adjustment
Clamp lever
Open
Close
Figure 147: Safety push handles with infinite height
adjustment
For adjusting the height of the push handles,
open the clamp lever by turning counter-clock-
wise (a half to a complete rotation). Then the
height of the push handles can adjusted. The
height can be infinitely adjusted. We recom-
mend adjusting both push handles to the same
height. Once the desired height is set, hold the
push handles in this position and then close
the clamp lever again clockwise with a half to
complete rotation.
Note:
If the clamp lever knocks against the push han-
dle when turning it, you can pull the clamp
lever out perpendicular to the rotary axle, re-
lease it again in another angle position via the
integrated serration and keep on turning. This
also permits the position of the clamp lever to
be aligned to the back tube after performing
the height setting so that this does not protrude
over the back tube to the side.
Video Safety push handles with con-
tinuous height adjustment:
https://www.youtube.com/watch?v=LFzG
stTQvuI
52