Proactive TRAVELER Service Booklet page 23

TRAVELER usage instructions
Top belt
Middle belt
Bottom belt
Figure 29: Belt system of the adaptable backrest up-
holstery with three belts
Top belt
Middle belts
Bottom belt
Figure 30: Belt system of the adaptable
backrest upholstery with four belts
To adjust the slack in the belt system, the
tensioning loop of the respective belt is held by
its strap and pressed to the right until the belt
slackens.
Tensioning loop with strap
Figure 31: Push the tensioning loop onto its strap on
the right
Press to the
right
Figure 32: Tensioning loop open completely
Now the belt can be pulled tight for setting a
small slack or loosened for a large slack (Fig.
33 and 34). The belt does not have to be
threaded out of the tensioning loops for this.
Pull the rear loop part to the left:
Reduce the slack
Figure 33: Reduce the slack
Pull to the right:
Increase the slack
Figure 34: Increase the slack
In order to put the tensioning loops back onto
the back system loosely again, pull the loop
section at the back to the left. You should dose
your pulling force with care in order not to ad-
just the set slack again.
22