Table of Contents
Advertisement
8.3
Detaching the adapter from the
product
The securing bolt is now pulled out completely
again to the outer stop, the pre-selection lever
grid mechanism is switched to "unlock" (upright
position) and the eccentric clamp lever is
turned to "loose".
Pre-selection lever grid mechanism
is switched upwards to "unlock"
Securing bolt removed
Figure 84: Preparation for detachment
Now hold down the product's brake and use
the grip rings on your wheelchair to move in
the direction of the product at the same time.
The product and wheelchair lift slightly until the
grid mechanism clicks out with an audible
noise. Then your wheelchair is lowered onto
the caster wheels again by taking the pressure
off the grip rings and the lock is detached. The
product can now be removed.
Figure 85: Press the product's brake and move
towards the product with the grip rings until it
unlocks
25
Usage instructions Adapter & Adaptation
Eccentric
clamp lever
to "loose"
Direction of
travel
Hint: If the surface is very smooth, it is benefi-
cial to hold the product against a wall or other
fixed barrier until the grid mechanism is
stopped using a clearly audible noise.
Note: You can watch a video on how to de-
couple the product on YouTube:
https://www.youtube.com/watch?v=Vy
NX65X8mtc
9
WHEEL-E: Adaptation on the
product and detachment from
product
The adaptation of the adapter on the product is
shown below using the central adapter. The
approach also applies to the front adapter.
9.1
Terminology
Here you will find an illustration of the terms
used in the following to make it easier for you
understand:
Pre-selection lever
Insertion shaft
grid mechanism
Eccentric
Mount for
clamp lever
safety bolts
Figure 86: Adapter head terms
Advertisement
Table of Contents
