Fr3 Mounting Instructions - Eaton PowerXL DM1 Series Instruction Leaflet

PowerXL DM1 and DM1 Pro series VFD

FR3 mounting instructions

Step 1.
Lift the drive out from the carton, remove the packaging. The
magnetic cores and cable ties are only included in EMI version drive.
Step 2.
Screw mounting: Attach the drive to the mounting plate with four
M5X20 (or 3/16 in.) screws and four M5 (or 3/16 in.) nuts. The
opening dimension on the mounting plate should follow required
dimension (refer to the dimension drawing in the instruction leaflet).
DIN Rail mounting: Lift the drive at an angle about 30 degrees.
Align the top hooks of drive DIN rail mounting slot with DIN rail top
edge. Push down and rotate the drive to clip the bottom hooks on
the bottom DIN rail edge.
Four M5x20 or 3/16 inch screws
Four M5 or 3/16 inch nuts
Torque: 3 N.m (26.6 lb/in.)
Screw mounting
+
Step 3. (EMI version only):
The input wires (including three line wires and one input grounding
wire) should run through the input magnetic core before connecting
to input terminal block and grounding hole. Use a cable tie to tie the
input magnetic cores to the input wires.
For 3-phase FR3 EMI version, the output wires (only three motor
wires) should run through the output magnetic core before connect-
ing to output terminal block. The output grounding wire should not
run through the output magnetic core. Use a cable tie to tie the
output magnetic cores to the output wires. For 1-phase FR3 EMI
version, there is no output magnetic core. The motor wires and
output grounding wire can be connected to corresponding terminals
directly.
The maximum distance between input / output magnetic cores top
surface and drive bottom surface is 100 mm.
The input magnetic core and output magnetic core are the same for
3-phase FR3 EMI version.
Input magnetic core
Input grounding wire
Instruction Leaflet
Effective December 2021
DIN Rail mounting
Max. distance: 100 mm (3.94 in.)
Output magnetic core
Output grounding wire
3 motor wires
3 line wires
EATON www.eaton.com
PUB53675
9