Fr1 Mounting Instructions; Screw Mounting - Eaton PowerXL DM1 Series Instruction Leaflet

PowerXL DM1 and DM1 Pro series VFD

FR1 mounting instructions

Step 1.
Lift the drive out from the carton and remove the packaging. The
magnetic cores and cable ties are only included in EMI version drive.
Step 2.
Screw mounting: Attach the drive to the mounting plate with
two M5x20 (or 3/16 in.) screws and two M5 (or 3/16 in.) nuts. The
opening dimension on the mounting plate should follow required
dimension (refer to the dimension drawing in Table 1 of this docu-
ment).
DIN Rail mounting: Lift the drive at an angle about 30 degrees.
Align the top hooks of drive DIN rail mounting slot with DIN rail top
edge. Push down and rotate the drive to clip the bottom hooks on
the bottom DIN rail edge.
Two M5x20 or 3/16 inch screws
Two M5 or 3/16 inch nuts
Torque: 3 N.m (26.6 lb/in.)

Screw mounting

+
Step 3. (EMI version only):
The input wires (including 3 line wires and 1 input grounding wire)
should run through the input magnetic core before connecting to
input terminal block and grounding hole. Use a cable tie to tie the
input magnetic cores to the input wires. The output wires (only 3
motor wires) should run through the output magnetic core before
connecting to output terminal block.
The output grounding wire should not run through the output
magnetic core. Use a cable tie to tie the output magnetic cores to
the output wires. The maximum distance between input / output
magnetic cores top surface and drive bottom surface is 100 mm
(3.94 in.). The input magnetic core and output magnetic core are the
same for FR1.
Input magnetic core
Input grounding wire
Instruction Leaflet
Effective December 2021
DIN Rail mounting
Max. distance: 100 mm (3.94 in.)
Output magnetic core
Output grounding wire
3 motor wires
3 line wires
EATON www.eaton.com
PUB53675
7