Table of Contents
Advertisement
Leak Detector
Info mode
Agilent CrossLab CS Electronic Leak Detector Operation Manual
Buzzer
When the leak detector is on, the buzzer setting defaults to On.
This means that the leak detector is able to give an audible alert
when the number of bar levels displayed are greater than two.
To change the buzzer setting:
1
With Info mode displayed, briefly press and release the
Enter/Clear/Toggle button to cycle through available
screens until the Buzzer screen is displayed.
2
Press and hold the Enter/Clear/Toggle button for
two seconds to toggle between On and Off options. The
buzzer function changes based on the selected option.
Auto off
In battery power mode, the unit defaults to "auto off" when the
power is on. This means that every time the unit is activated, a
"power-off" cycle begins, lasting for 10 minutes. The leak
detector will operate continuously until it is manually turned off.
In USB power mode, the Auto off function is always off and the
option to change the Auto off setting is disabled.
To change the Auto off setting:
1
With Info mode displayed, briefly press and release the
Enter/Clear/Toggle button to cycle through available
screens until the Auto off screen is displayed.
17
Advertisement
Table of Contents
