Leak Detector
Notes, Cautions, and Warnings
Notes, Cautions, and Warnings
NOTE
CAUTION
WARNING
8
Agilent CrossLab CS Electronic Leak Detector Operation Manual
•
The tubing is not replaceable. Do not attempt to remove
the tubing.
•
The filter is the only serviceable part in the leak
detector cartridge.
•
Annual calibration for the leak detector cartridge is
not necessary.
•
Update to the latest firmware if the leak detector cartridge
is being used with ADM Flow Meter mainframe with
firmware version 1.2.1911.1501 and below.
•
Do not use the leak detector to detect corrosive gases.
•
Do not expose the probe tip to extreme sources of heat.
•
Do not use the leak detector to probe in areas where
there are solvents or liquids (such as snoop).
•
Do not use the leak detector in temperatures outside of
its specified operating range.
•
Do not use the leak detector in high humidity
environments outside of its specified humidity range.
•
The probe should not be misused for other purposes
except to conduct sniffing in suspected leak areas.
•
Use only a 5 V DC, 0.5 A USB power source and the
supplied USB cable to run this device.
•
Do not use the leak detector in hazardous environments
where there are large leaks of flammable gases.
•
Do not use the leak detector as safety equipment.