Connecting The Scansnap And A Mobile Device (Ix500) - Fujitsu ScanSnap iX1600 Basic Operation Manual

Connecting the ScanSnap and a Mobile Device (iX500)

You can use the ScanSnap Wireless Setup Tool Wizard to complete the preparation for connecting
the ScanSnap to a mobile device.
For details, refer to "Connecting the ScanSnap to a Wireless LAN (iX500/iX100)" (page
The following explains how to connect the ScanSnap and a mobile device when the wireless settings
have already been configured by using the ScanSnap Wireless Setup Tool Wizard.
1.
Start ScanSnap Connect Application on your mobile device.
a The mobile device will automatically be connected to an available ScanSnap on the same
network.
HINT
l If more than one available ScanSnap is detected, or if ScanSnap Connect Application is set
not to connect a mobile device to a ScanSnap automatically, then tap the ScanSnap that you
want by name, in order to connect to the mobile device, under [ScanSnap] on the [Connect
to] screen. For details, refer to the Basic Operation Guide (Mobile Connection) for your
mobile device.
l A notification appears in the following cases:
- When the ScanSnap and the mobile device are connected via wireless LAN, and the
communication with ScanSnap Manager is disconnected
- When you log onto the computer which is connected to the ScanSnap with the ScanSnap
and the mobile device already connected via wireless LAN
Connecting the ScanSnap to a Computer or Mobile Device via Wireless LAN (iX500)
133
129).