Fujitsu ScanSnap iX1600 Basic Operation Manual page 227

ATTENTION
When the [Place document face up] checkbox is selected in the [Scanning mode option] window,
place the document in the Carrier Sheet face-up and bottom edge down.
To open the [Scanning mode option] window, click the [Option] button in the [Scanning] tab of the
"ScanSnap Setup Window" (page
7.
Press the [Scan] button on the ScanSnap to start a scan.
a When scanning is completed, the scanned image is saved.
ATTENTION
l The scanned image is output at the center of the page in the size specified for [Paper size] in the
[Carrier Sheet Settings] window.
l If [Automatic detection] is specified for [Paper size] in the [Carrier Sheet Settings] window, an
optimal size will be selected automatically from the available standard sizes in [Paper size]. Note
that the size of the image may become smaller than the original document depending on the
document scanned, or part of the image may appear missing.
Example: When the contents are printed to fit in A5 size in the center of an A4 size document,
the scanned image is output in A5 size.
To output the scanned image in its original size, specify the document size in [Paper size].
HINT
l In the following cases, place a blank (white) sheet of paper underneath the document when
scanning:
- The scanned image is not saved in the correct size (when [Automatic detection] is selected for
[Paper size] in the [Carrier Sheet Settings] window)
- Shadows appear around the edges of the scanned image
- Black lines appear around the edges of a uniquely shaped cutting
Back
88).
227
Scanning Documents with iX500