Cleaning The Carrier Sheet (Ix1500/Ix500/Ix100/S1100I) - Fujitsu ScanSnap iX1600 Basic Operation Manual

Cleaning the Carrier Sheet (iX1500/iX500/iX100/
S1100i)
As you keep using the Carrier Sheet, dirt and dust will accumulate on the surface and the inside.
Clean the Carrier Sheet regularly because it may result in scanning errors.
The procedure for cleaning the Carrier Sheet is as follows.
Cleaning
Gently wipe the dirt and dust off the surface and the inside of the Carrier Sheet with a dry cloth, or a
cloth moistened with Cleaner F1/mild detergent.
ATTENTION
l Do not use paint thinner or any other organic solvents.
l Do not apply too much force when rubbing. Doing so may damage or deform the Carrier Sheet.
l Be careful not to leave any crease on the Carrier Sheet.
l After cleaning the inside of the Carrier Sheet with a cloth moistened with Cleaner F1/mild detergent,
make sure that it is completely dry before closing the Carrier Sheet.
l The Carrier Sheet should be replaced approximately every 500 scans.

Cleaning the Carrier Sheet (iX1500/iX500/iX100/S1100i)

451