Connecting The Scansnap To A Mobile Device - Fujitsu ScanSnap IX500 Operating Instructions Manual

Connecting the ScanSnap to a Mobile Device

By using the ScanSnap Wireless Setup Tool Wizard, you can configure and check the connection
between the ScanSnap and a mobile device.
For details, refer to "Setting a Wireless LAN Using the ScanSnap Wireless Setup Tool" (page
The following explains how to connect the ScanSnap and a mobile device when the wireless settings
have already been configured by using the ScanSnap Wireless Setup Tool Wizard.
1.
Start ScanSnap Connect Application on your mobile device.
a The mobile device will automatically be connected to an available ScanSnap on the same
network.
HINT
l If more than one available ScanSnap is detected, or if ScanSnap Connect Application is set
not to connect a mobile device to a ScanSnap automatically, then tap the ScanSnap that you
want by name, in order to connect to the mobile device, under [ScanSnap] on the [Connect
to] screen. For details, refer to the ScanSnap Connect Application User's Guide for your
mobile device.
l A notification appears in the following cases:
- When the ScanSnap and the mobile device are connected via wireless LAN, and the
communication with ScanSnap Manager is disconnected
- When you log onto the computer which is connected to the ScanSnap with the ScanSnap
and the mobile device already connected via wireless LAN
Connecting the ScanSnap via Wireless LAN
57
54).