Replacing Consumables For Ix500 - Fujitsu ScanSnap iX1600 Basic Operation Manual

Replacing Consumables for iX500

The Roller Set consists of the brake roller and pick roller.
Replace each roller in the following procedure:
ATTENTION
The bottom part of the ScanSnap may become hot when the ScanSnap is being used but this does not
affect ScanSnap operation or cause any physical harm. Be careful not to drop the ScanSnap when
carrying it.
1.
Unplug the power cable from the AC outlet.
2.
Remove any documents from the ADF paper chute (cover).
3.
Pull the ADF release tab towards you to open the ADF top section.
4.
Replace the brake roller.
1. Open the brake roller cover.
Hold both ends of the cover, and open it in the direction of the arrow.
l Before replacing consumables, you must turn off the ScanSnap and unplug
the power cable from the AC outlet. Not doing so may cause fire or electrical
shock.
l Do not place internal parts such as the brake roller and the pick roller within
reach of small children. Doing so may cause injury.
ADF Paper Chute (Cover)
ADF Release Tab
ADF Top Section
464
Replacing Consumables for iX500