Device Layout - Wirepath Surveillance WPS-300-CUB-IP Installation Manual

Ip cube camera
Table of Contents

Advertisement

WPS-300-CUB-IP Installation Manual

5.1. Device Layout

1.
2.
3.
4.
1.
IR LEDs — Infrared LEDs illuminate nighttime scenes.
2.
Fine Focus Adjustment Ring — Turn the ring up to one revolution to make fine focus adjustments for the clearest image.
3.
Built-in Microphone — Picks up audio near the camera and streams it with video.
4.
PIR Sensor Motion Detector — Passive Infrared Sensor detects motions for triggering record and contact closure events.
5.
Built-in Speaker — Output audio from a connected device's microphone (if equipped) like a PC or smartphone.
6.
Relay Contacts (Spring Loaded Terminals) — Monitor the state of a contact closure (DI) or control a device via relay (DO)
during motion and alarm events.
7.
1/4"-20 Threaded Mounting Hole — Attach the included mounting base, or any base with male 1/4"-20 threads.
8.
Default Button — Press and hold for 30 seconds while powering the camera to return all camera settings to default.
9.
Audio Out (1/8" / 3.5mm Stereo) — Connect a 1/8" (3.5mm) stereo-mini cable to an amplifier input to send audio out from the
camera's web interface.
10. Ethernet Connection (RJ45) — Connect to network switch for communication to and from the camera. Pin out follows EIA
standard 568-B. If the network port used supports PoE standard IEEE 802.3af then power can be provided on the Cat5e/6
connection.
11. 12V DC Power In — No power supply is needed if PoE is being used to power the camera via the Ethernet connection.
Connect to a 12V DC power supply if PoE is not being used. A power supply is not included with the camera.
Warning! Use only a 12V DC power supply with this camera. Higher voltages or AC current will cause permanent damage
that is not covered by the warranty.
12. Service Tag — Displays the service tag number and camera model information.
13. MAC Address Tag — The MAC address is used during setup and is helpful information to save. Record the MAC addresses of
all equipment in the system in your job records.
10
6.
7.
8.
5.
9.
10.
11.
12.
13.

Advertisement

Table of Contents
loading

Table of Contents