Video Settings Menu Overview; Video Setting (For Bnc Test Adapter Output); Streaming 1 And 2 Setting; Streaming 3 (Jpg/Mjpeg) - Wirepath Surveillance WPS-300-CUB-IP Installation Manual

Ip cube camera

Table of Contents

9.4.3. Video Settings Menu Overview

The Camera supports up to four streams that can be used for streaming to a mobile device, network recorder, control system GUI,

or the browser GUI simultaneously. While the highest quality is desired, it may not be supported by the network or device.

9.4.3.1.

Video System Set the video system for the country of installation for PAL or NTSC. Default: NTSC

Corridor

Mode

Click "Apply" at the bottom-right of the page to save modified settings.

9.4.3.2.

Streams 1 and 2 are used for most streaming connections, including the web browser view, NVR's (uses both streams),

and mobile app access. Stream 1 is set to the best quality that can be used for the camera for the given application.

External factors like network traffic or a slow Internet connection limit the quality. Stream 2 can be set to output a

different stream type (H.264 or MJPEG) or to a lower quality setting. If a camera is accessed by a Wirepath™ NVR,

Stream 2 will be forced open so that recording takes place. See section for complete overview and setup of streaming

settings.

9.4.3.3.

Stream 3 only outputs MJPEG format, primarily for use in automation systems that allow live camera views through

touch panels. (Control4, Crestron, etc.) Frame Rate and Resolution settings are inherited from Stream 2. The

compression may be changed for faster streaming from slow networks.

9.4.3.4.

(3rd Generation Partnership Project) Streaming for older phones. Limited resolution and frame rate for devices with very

small amounts of memory or processor power.

Turn to "90" or "270" for a corrected aspect ratio if the camera is focused down a long hallway.

WPS-300-CUB-IP Installation Manual

Table of Contents