Installation And Connection - Bartscher M 5110 Manual

•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.

5.2 Installation and connection

CAUTION!
Installation and maintenance can only be performed by qualified personnel!
Installation
•
Unpack the device and remove all packing material.
•
Place the device on a flat, secure surface that can support its weight and is resistant
to high temperatures.
•
Never place the device on a flammable surface.
•
Do not place the device near an open flame, electric or coal oven, or other heat
source.
•
Never place the device directly against walls, kitchen furniture or other flammable
objects. Proceed according to relevant fire safety regulations.
•
Keep a minimum of 100 mm between the device and walls/other objects on the left
and right sides and at the rear, and 150 mm from the top.
•
To make dampening and height adjustments, use the adjustable legs as shown in
the above diagram. Large differences in height or tilt can negatively impact the
device's operation.
•
Place the device in a well-ventilated area. The device may only be installed in a
space with proper ventilation, optimally under an oven hood that will direct fumes to
the outside.
•
Ensure that ventilation openings are not blocked in any way.
•
Before first use, remove the protective foil from the device. Peel the foil off slowly, so
as not to leave any glue. If some glue remains, remove it using an appropriate solvent.
CAUTION!
The device is not designed to be built-in!
34