Table of Contents
Advertisement
Figure 105. Removing the right control panel
Next steps
Replace the right control
Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the front
bezel.
4.
Remove the backplane
5.
Remove the air
shroud.
Steps
1. Route the control panel cable through the latch, side wall of the system, and then slide the cable into the clip.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the right control panel in the slot on the system.
3. Connect the right control panel cable to the connector on the system board.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
panel.
Safety
Before working inside your
cover.
instructions.
system.
Installing and removing system components
103
Advertisement
Table of Contents
