Softstart Setting; Setting The Humidifier; After Use - Weinmann homecare SOMNOsoft + WM 24600 Description And Operating Instructions

5.4 Softstart setting

If Softstart is activated on your device, the Softstart time can be selected in 5-minute steps
up to a maximum of 30 minutes.
2. Press the Softstart button
The SOMNOsoft + increases the time up to the maximum of 30 minutes and then starts
again at the minimum time of 5 minutes.
If 4 seconds elapse without any button being pressed, the Softstart time displayed is
stored and the LC display stops flashing.
The Softstart settings are preserved even after the device is switched off. Whenever the
SOMNOsoft + is used, it automatically starts in Softstart mode if this was activated last
time.
Softstart can be switched on or off at any time by briefly pressing the Softstart button

5.5 Setting the humidifier

To set the humidifer heating level, press the button
until the figure beside the
you alter the humidifier heating level by one step (from 1 to 6). The value displayed is stored
if 4 seconds elapse without any button being pressed.
For further details on setting the humidifier, please consult the relevant operating
instructions.

5.6 After use

1. Take off the cap or headstraps with the mask.
2. Press the On/Off button
device switches off automatically after about 5 seconds.
16 Operation
1. Switch the SOMNOsoft + on and press the Softstart
button . Keep the button pressed until the display for
25
the Softstart time
repeatedly to increase the Softstart time in 5-minute steps.
25
Use the humidifier button
and off. When the humidifier is operating, the humidifier
indicator light
display.
symbol starts flashing. Every time you press the button
to switch the device off. If auto switch-on was selected, the
24
starts flashing.
16
to switch the humidifier on
26
is on and the
27
while the SOMNOsoft + is running
26
symbol appears in the
26
.
25