Table of Contents
Advertisement
Chapter 11. Troubleshooting
Problem
High frequencies and muscle artifacts
make ECG signal noisy.
(This may occur concurrently with AC
noises)
Noisy ECG signal due to AC power
interferences
Possible Cause
● Patient has stress or placed in
an uncomfortable condition.
● Patient feels cold and starts
shaking.
● Improper placement of patient
hands and feet.
● Bed dimensions are not
suitable for comfortable
placement of patient hands and
feet.
● Limb electrodes are attached
tightly.
● Electrodes are placed on bony
site of the patient body.
● Unclean or sulfated electrodes
● Insufficient gel is applied.
● Contact with metal parts of
bed, trolley, etc.
● Lead wires, patient cable or
power cable fails to make
connection.
● There are other electronic
devices in the vicinity of the
electrocardiograph.
● Improper ambient light for
example using fluorescent lamp
in the room which ECG record
is taken.
● Incorrect HUM Filter is used.
● Improper Earth system
54
Solution
● Relax the patient.
● Check electrodes connection.
●If the problem persists, use
Low pass filter.
● Call After- Sales Services.
● Check electrodes and lead wires
connection.
● Check that lead wires are not
tangled.
● Check that the patient does not
contact the metal parts.
● Check that patient cable and power
cable have no contact.
● Check the selected HUM Filter.
● If the problem persists, unplug the
power cable (the device runs on the
battery).If the problem is solved, you
can make sure that noise source is the
device's power supply.
● If the problem still persists, noise
source may be other devices, room or
its earth system. Consequently this
room is not suitable for ECG
recording.
Advertisement
Table of Contents
