Table of Contents
Advertisement
Appendix IV – EMC
Use only the recommended manufacturer accessory .Using the
accessory other than in relevant chapter may cause to increase the
EMISSION or decrease the IMMUNITY of system.
Measurements can be affected by mobile and RF communications
equipment. It should be assured that the Electrocardiograph is
used in the specified electromagnetic environment
To prevent EMC effect on the Electrocardiograph, the system
should not be used adjacent to or stacked with other equipment and
that if adjacent or stacked use is necessary, the equipment should be
observed to verify normal operation in the configuration in which it
will be used.
Do not use cellular phone in the vicinity of this equipment. High
result in strong level of electromagnetic radiation emitted from such
devices may interference with the Electrocardiograph performance.
Guidance and manufacturer's declaration – electromagnetic emissions
The Dena350 Electrocardiograph is intended for use in the electromagnetic environment
specified below. The customer or the user of the Dena350 should assure that it is used in such an
environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
APPENDIX IV
EMC
Compliance
Electromagnetic environment - guidance
The Dena350 uses RF energy only for its internal
function. Therefore, its RF emissions are very low
Group 1
and are not likely to cause any interference in
nearby electronic equipment.
Class B
The Dena350is suitable for use in all
establishments, including domestic establishments
Class A
and those directly connected to the public low-
voltage power supply network that supplies
buildings used for domestic purposes.
Complies
62
Advertisement
Table of Contents
