Mounting And Removing Lens Ports - Fantasea Line FA6000 Instruction Manual

2. Store the cover for possible future use.
3. Follow the instructions provided with the selected accessory product in order to install it
inside the housing and make sure the M16 port accessory installed consists of an O-ring for
maintaining the watertight seal of the housing.
Important
Note

MOUNTING AND REMOVING LENS PORTS

The housing features an FML interchangeable lens port system, which allows using a wide range of
lenses underwater. The housing is compatible with any FML lens port, as well as other lens ports
available in the market. For compatibility information and lens ports available, please visit the Fantasea
website – www.fantasea.com
1. Mounting a lens port on the housing:
a. If possible, it is recommended to mount the lens port on the housing prior to
installing the camera inside. If using exceptionally large lenses which cannot be
installed on the camera prior to inserting it into the housing, the camera and lens can
be installed inside the housing prior to mounting the lens port. Please refer to section
"Installing the Camera" - step 18.
b. For smooth installation and
removal of the lens port, it is
recommended to apply a slight
amount of silicone grease over
the lens port O-ring prior to
installing it on the housing.
c. Place the housing on a
protected surface.
d. Turn the lens port lock
rightwards, so it's seated at the
"UNLOCK" position (image
#13).
Once an accessory has been installed using the M16 port, it important to
carry out the first dive with the housing empty (no camera installed
inside) in order to verify that the housing watertight seal has not been
affected during the replacement
Image #13
FA6000 Housing Instruction Manual 20190204
20