Fantasea Line FA6000 Instruction Manual page 26

8. Mount the camera on the tray by installing the
mounting screw featured on the tray into the
mounting screw hole found at the bottom of
the camera (image #25). Make sure to follow
the diagram printed on the tray and install the
camera facing forward. Once the screw has
been tightened, make sure that the camera is
positioned steadily on the tray.
9. Note that the camera battery compartment can
be opened when the camera is installed on the
tray, allowing for easy and quick battery and
memory card replacement without having to
remove the camera from the tray.
10. Prior to installing the tray and camera into the
housing:
a. Make sure that the built-in flash is pushed
down into the camera body. Any attempt
of installing the camera into the housing
with the flash popped-up might damage
the camera and the housing and will
necessarily interfere with a proper
watertight seal of the housing.
b. Make sure the camera is turned off and
that the housing On/Off control is set at the
"Off" position as well.
c. Turn the AEL/AF/MF control on both the
camera and the housing to AEL. Failing to do so will disable the control once the camera
is accommodated inside the housing.
d. Turn the Mode Dial on the camera and housing so the Auto (green symbol) shooting
mode is selected and aligned with the white mark on the left of the wheel (image #26).
Image #26
Image #24
Image #25
FA6000 Housing Instruction Manual 20190204
26