Fantasea Line FA6000 Instruction Manual page 18

c. Using the screwdriver included in the kit, remove the screw that secures the shutter
release trigger (image #6). Store it safely, although a spare screw is included in the kit.
Image #5
d. Remove the trigger by pulling it out and away from the housing (image #7). Note that
once the trigger has been removed, the control metal shaft can be accidently pushed
in, resulting with the spring in the interior of the control slightly moving out of place
and thus disabling proper operation of the control. Therefore, make sure not to push
the control shaft into the housing. Store the removed trigger for possible future use.
e. Install the replacement extended trigger on the exposed metal shaft of the control by
aligning the protrusion featured on the control with the shape of the shaft (image #8).
Image #7
f. Using your finger, apply slight counterforce on the control inside the housing to prevent
the shaft from being pushed into the housing while installing the replacement extended
trigger.
g. Using the screwdriver, install the screw in order to secure the replacement extended
trigger in place (image #9 on the following page).
Image #6
Image #8
FA6000 Housing Instruction Manual 20190204
18