Fantasea Line FA6000 Instruction Manual page 27

This will allow for the camera and housing mode
dials to be aligned, so the housing mode dial will
indicate the proper mode selected by the camera
dial.
e. Pull the housing Mode Dial up and away from the
housing to allow for smooth installation of the
camera (image #27).
11. Install the tray with camera into the camera tray port by
holding the tray parallel to the housing, aligning
the rods of the tray with those featured on the
tray port and sliding the tray all the way in (image
#28).
12. Take special care not to touch or damage the
moisture detector device when installing the
camera. The Device is located inside the housing
on the inner (right) side of the housing interior to
the latch dial.
13. Turn the camera tray port lock leftwards, to the
"LOCK" position (image #29). Make sure that
the tray was properly installed and locked by
gently trying to pull it out.
14. Realign the camera LCD screen by slightly
pushing its bottom inwards and pulling its top
outwards until it reaches a complete vertical
angle (image #30).
15. If making use of any electronic triggers, such as a LED
Flash Trigger or an electronic strobe bulkhead, attach
the accessory to the camera hot-shoe connection.
16. If inserting a silica gel pack inside the housing in order to
prevent moisture, it is best to insert it on the left side of
the camera and to attach it with tape to the housing
wall, where it doesn't interfere with proper housing
operation. It is important to make sure that the silica gel
pack doesn't stick out, or else it might interfere with the
watertight seal of the housing.
17. Close the housing (see section "Closing the Housing").
18. When using an exceptionally large lens, you might find
Image #27
Image #28
Image #29
Realign camera LCD screen
Image #30
FA6000 Housing Instruction Manual 20190204
27