Fantasea Line FA6000 Instruction Manual page 22

k. If the lens port features a lens cap,
it's best to secure it with a secure
string to one of the housing lanyard
loops.
l. Note that lens ports offered by
various manufacturers might
feature assembly and locking
markings that are either different
than those featured on the housing
or placed differently. If mounting
such lens ports on the housing and encountering resistance when attempting to push
the port against the housing, simply turn the port a bit until reaching the point where
the port can be inserted completely into the housing, even if housing and port
markings are no longer aligned. Continue with steps "h" and "i" above to make sure
the port has been properly installed and locked.
Important
Note
2. Removing a lens port from the housing:
a. Make sure to dry the housing exterior prior to opening the lens port in order to avoid
water coming in contact with the camera or lens once the lens port is removed.
b. If the lens cap is secured to the housing with a snap cord or secure string, detach the
string or remove the lens cap.
c. Turn the lens port lock rightwards, so it's seated at the "UNLOCK" position (image #13
on page 20).
d. Hold the housing in one hand and the lens port with the other. Turn the lens port
counterclockwise until reaching a point where it can't be turned any farther. The
white marking on the lens port should now be aligned with the white marking on the
housing (image #14 on page 21).
e. If encountering resistance when attempting to turn the lens port counterclockwise as
a result of significant pressure changes, it is recommended to use the FML1 lens port
opening tool. Insert the lens port opening tool into the dedicated slots found on the
front ring of the lens port (image #18 on the following page). Use the lens port
opening tool to turn the lens counterclockwise while carefully applying slight pressure
Once a lens port has been mounted on the housing, it is important to test
the housing empty (no camera installed inside) in a body of water in order
to verify that the housing watertight seal has not been affected during lens
port installation.
Image #17
FA6000 Housing Instruction Manual 20190204
22