Ke6910 Point-To-Point Installation - ATEN KE6900ST User Manual

KE6910 Point-to-Point Installation

Setting up the KE6910 / KE6912 system in a point-to-point configuration is
simply a matter of plugging in the cables.
Note: In a point-to-point configuration, no administrator setup is necessary.
Make sure that all the equipment is powered off. Refer to the installation
diagrams on the next two pages and do the following:
1. (Optional) Use the grounding wire to connect the extender's grounding
terminal to a suitable grounded object.
2. On the transmitter side, plug the mouse, keyboard, DVI-D monitor, serial
devices, microphone and speakers into the ports on the Console section of
the KE6910T / KE6912T.
3. Connect the USB DVI-D KVM cable provided with this package into the
KVM Ports and the audio ports on the front of the KE6910T / KE6912T.
4. Connect the other end of the USB DVI-D KVM cable into the keyboard,
video, mouse, speaker and microphone ports on the computer.
5. For control of serial devices, connect the RS-232 port on the front of the
transmitter to a serial port on the computer.
6. Connect a Cat 5e/6 cable to the KE6910T / KE6912T's LAN port.
7. On the receiver side, plug the mouse, keyboard, DVI-D monitor, serial
devices, microphone, and speakers into the ports on the Console section of
the KE6910R / KE6912R.
8. Connect the other end of the Cat 5e/6 cable to the KE6910R / KE6912R's
LAN port.
9. Instead of connecting through the LAN ports, you can choose to connect
the KE6910 / KE6912 through the SFP slots. To do so, plug SFP modules
into the transmitter and receiver's SFP slots, then connect each end of
Gigabit Ethernet (GbE) optical fiber between the SFP modules.*
10. Plug the power adapters into AC sources with the power cords; then plug
the other ends into the transmitter and receiver's power jacks respectively.
The KE6912 supports Power over Ethernet (PoE), thus the power can be
supplied through PoE network switch, without the need of a power
adapter.
Chapter 2. Hardware Setup
69