KVM over IP Matrix System User Manual
KE9900ST (Transmitter) Front, Rear and Side View
No.
Component
1
Reset
2
LAN LED
3
Power LED
42
This switch must be pushed with a thin object, such as the
end of a paper clip.
Press and release to reboot the device.
Power off, hold reset then power on the device while
pressing reset to recover from a firmware upgrade
failure.
Press and hold it in for more then three seconds
resets the unit back to its factory default settings.
This LED indicates the network status.
Lights when connected to the LAN and blinks when the
Ethernet connection is active:
Orange: 10 Mbps
Orange + Green: 100 Mbps
Green: 1000 Mbps
Off when not connected to the LAN.
Lights blue to indicate the unit is turned on.
Description