ATEN KE6900ST User Manual page 126

KVM over IP Matrix System User Manual
Item
RS232 Settings
Enable Media
Manager
Address
Beeper
Touch Screen
Calibration
108
Configure the serial device settings for the Receiver. The
default settings are:
Baud Rate: 9600
Parity: None
Data Bits: 8 bits
Stop bits: 1 bit
Flow Control: None
Select which type of media the Receiver can stream from
Transmitters: Video, Audio, USB, and RS232. For KE8950
Series models, use the radio button to set the source of the
audio signal: HDMI, Analog, or Both.
Set the IP address and Port number of the computer running
the KE Matrix Manager software. The default port number is
9110.
Check this box to allow the Receiver to beep when configuration
changes are made to it.
Use this button to calibrate the surface of a USB touch screen
connected to the unit. When the calibration screen appears,
+
touch the flashing
complete.
Description
symbol at each corner until the process is