ATEN KE6900ST User Manual page 135

Item
Transmitter To set the Transmitter's video settings:
Video Attributes
Video Type: Select the DVI video connector being used by the
display: Digital (DVI-D) or Digital (DVI-I). This option is available
for KE6900 units and will be grayed out for other models.
Color Depth: Select the number of bits to use for the color
depth: 24, 16, or 8. This is the number of bits used to describe
the color of a single pixel. A bit depth determines the number of
colors that can be displayed at one time.
Bandwidth Limit: Select the maximum bandwidth that the
Transmitter can use to transmit video over the network. A lower
bandwidth setting transmits lower quality video; a higher
bandwidth setting sends higher quality video but this can affect
network speed.
Video Quality: Select the video quality to use. 5 is the highest
video quality, and 1 is the lowest video quality. Options are: 1~5.
Background Refresh: Sets how often the Transmitter
refreshes the background image on the connected display.
Options are to refresh every 256,128, 64, 32,16, or 0 frames.
Beeper Check this box to allow the device to beep every time a
configuration change is made.
Occupy Timeout Set a time threshold for devices whose Access Mode has been
set to Occupy (see Access Type, page 172). If there is no
activity from the Receiver occupying the port for the amount of
time set here, the Receiver is timed out and the port is released.
The first Receiver to send keyboard or mouse input after the
port has been released gets to occupy the port. Input a value
from 1 to 240 seconds.
After entering the information, click Save.
Chapter 3. OSD Operation
Description
117